Installing Awning Sun 3000 outside in front of the gutter

For extra height for windows and doors, mount the awning on the eaves of the house. Either under the gutter or out in front of the gutter for extra height. How to install Sun 3000 Awning in front of the gutter.

 

Mounting in front of the gutter on roofs with a 25 degree pitch. For maximum height, the awning can be mounted in front of the gutter with our special brackets for roofs with a 25 degree pitch. When measuring the awning, measure from rafter to rafter to your desired size.

 

Installation instructions

MOUNTING ON EAVES - STEP 1

Measure the awning size to your rafters and desired location

The brackets can be on both sides, set where the dimensions fit. 

MOUNTING ON EAVES - STEP 2

Dimensions and markings for routing rafter brackets in the starboard side

First measure and mark the bottom edge of the rafter to know the position of the rafter on the starboard side. 

MOUNTING ON EAVES - STEP 3

Countersink in the stringboard from the inside of the rafter bracket


MOUNTING ON EAVES - STEP 4

Measure the rafter brackets and complete the routing in the stern board


MOUNTING ON EAVES - STEP 5

Insert the rafter bracket, ensure it is vertical and attach to the rafters


MOUNTING ON EAVES - STEP 6

Mount the mounting bracket and ensure they are in place


MOUNTING ON EAVES - STEP 7

Carefully unpack the awning, loosen the gripping blocks and snap the awning into the brackets.

Loosen the mounting brackets at the back of the awning corners and then lift the awning up to the height of your mounted brackets, click your awning in and tighten the brackets.


MOUNTING ON EAVES - STEP 8

Connect power to the awning by an electrician. electrician

All electrical work must be done by an electrician. electrician and so should the connection of your awning. Call your local electrician and have your awning connected to 230 V, 50 Hz.


MOUNTING ON EAVES - STEP 9

Adjust the tilt of the awning

After connecting, adjust the awning to the correct tilt to allow water to run off and not interfere with your open windows and doors. We recommend an inclination of approximately 25 degrees.

Extend the awning half a meter with your remote control. Adjust the tilt by loosening the bolts in the end caps of the awning with a 13 mm wrench and determine the tilt with a 6 mm Allen key. 


Do you need help?

If you have questions about maintenance or want a professional service, call +4570262140 or write to service@alux.dk


Related service guides


Previous
Previous

Mounting options Awning Sun 3000

Next
Next

Mounting Awning Sun 3000 on a wall